区域大气污染联防联控的理论与方法分析

区域性、复合型大气污染是中国目前以及今后一段时期内所面临的主要大气污染问题,但我国现行"属地"特征的环境管理制度无法满足区域性、复合型大气污染所需要的合作解决问题的要求,因此亟需建立区域大气污染联防联控机制。本文探讨了区域大气污染联防联控的理论基础,并着重讨论了我国实施区域联防联控的技术与方法,包括联防联控区域划分方法、区域大气环境问题控制技术、区域总量控制目标确定与分配方法及区域大气污染联防联控保障体系等。     

连续流动分析法测定降水中铵盐的可行性研究

铵盐是降水监测的重要指标之一,它对降水中的酸性物质具有中和作用。将连续流动分析法应用于降水中铵盐的检测,并对该方法的检出限、精密度、加标回收率等一系列实验室质量要求进行了测定;在此基础上,用连续流动分析法和国家标准分析方法进行比对试验。对测试结果进行数理统计分析后证明,连续流动分析法与国标方法无显著性差异。     

上悬窗条件下通风控制腔室火灾温度的实验研究

随着建筑结构的发展,上悬窗日益成为城市建筑窗户的选择,但这种通风条件下腔室火灾的发展特性仍缺乏研究。利用1∶8相似比例的缩尺寸腔室火灾实验台,实验研究了上悬窗不同开口尺寸、不同开窗角度下,通风控制的腔室火灾温度发展特性。实验结果表明,通风控制条件下,腔室火灾温度随着上悬窗开口尺寸和开窗角度的增加而增加,并通过能量平衡分析,建立了通风控制条件下,耦合上悬窗尺寸和开窗角度因素的腔室内部火灾温度预测模型。     

基于熵权物元可拓模型的智慧档案馆安全评估

为了评估智慧档案馆的安全状况,预防安全事故发生,通过分析智慧档案馆的安全因素,构建了由8个一级指标、38个二级指标构成的智慧档案馆安全评估指标体系,并将信息熵理论和物元可拓理论有机结合,构建了智慧档案馆安全熵权物元多级可拓评估理论模型。应用该指标体系和理论模型对某档案馆进行了实证研究,得出其安全等级为V级(安全),为该馆针对性地提出了加强安全工作的整改建议。评估结果与实际情况一致,验证了该评估指标体系和评估理论模型的正确性和可靠性。     

基于系统动力学的食品企业安全生产监管博弈研究

为了研究食品安全生产及监管的内在机理、影响因素及监管模式,采用演化博弈论方法建立了政府监管部门与食品企业之间的博弈模型,运用复制动态方程和系统动力学方法深入分析了食品安全生产中相关主体的决策选择。结果表明:食品企业在追求利益最大化的前提下须主动重视食品安全问题,食品企业的策略选择受安全生产投入成本、处罚成本和声誉收益的影响;政府监管部门的监管行为受监管成本、外部负效益及社会成本等多方因素的影响。因此,增大监管部门惩处力度、降低监管成本、完善社会公众监督机制、强化声誉效应是食品安全问题得以解决的有力保障。     

有限空间作业人员生理状态监测设备研制

为监测有限空间作业人员异常生理状况,进而保障有限空间作业安全与作业人员生命健康,在分析手腕处6个测量位置信号质量的基础上,获得最佳信号采集位置,并结合事故成因,从光电容积脉搏波(PPG)信号中提取心率、脉搏周期、振幅等生理参数作为评价指标,研制一款针对有限空间特殊作业人群的手腕处脉动生理信息监测设备;并进行系统稳定性测试。研究结果表明:手腕内侧中心位置为信号最佳采集位置;在有限空间运动状态下设备性能良好;研制的设备可以实现人员生理状态的实时无创监测与预警。     

基于光谱混合分析和反照率-植被盖度特征空间的土地荒漠化遥感评价

采用线性光谱混合分析模型对Landsat TM遥感影像进行混合像元分解,获取植被、裸土和水体组分的相对丰度分布;在反演地表反照率的基础上,构建了基于Albedo-Vegetation特征空间的土地荒漠化遥感监测模型;以黑河中游部分区域为例,进行了实证研究,并利用实地调查数据进行精度验证。结果表明:此方法充分利用了多维遥感信息,反映了荒漠化土地地表覆盖、水热组合及其变化,具有明确的生物物理意义,而且指标简单、易于获取,精度较高,有利于荒漠化的定量分析与监测。     

超高效螺旋式厌氧生物反应器流态研究

在冷态模拟条件下,采用脉冲刺激响应技术,运用轴向扩散模型和多釜全混流反应器串联模型研究了超高效螺旋式厌氧反应器的流态.结果表明:低负荷下超高效螺旋式厌氧反应器的流态趋于平推流(分散数D/uL0.2,串联级数N→∞);超高负荷下流态趋于全混流(D/uL≥0.2,N→1).反应器内总死区平均值为27.99%,其中,生物死区平均值为6.98%,水力死区平均值为21.01%.水力死区(Vh)与容积水力负荷(L)和容积产气速率(G)之间满足关系式:Vh=0.7603L+0.1627G-4.0620,容积产气速率对水力死区的影响大于容积水力负荷.超高效螺旋式厌氧反应器流态的适宜范围相当于等容多釜串联级数N≤3.01.最后提出了兼顾反应器传质效果和容积效能的控制措施.     

Modeling the e ects of constructed wetland on nonpoint source pollution control and reservoir water quality improvement

This article describes the integrated modeling approach for planning the size and the operation of constructed wetlands for maximizing retention of nonpoint source pollutant loads and reservoir water-quality improvement at a catchment scale. The experimental field-scale wetland systems (four sets, 0.88 ha each) have been in operation since 2002, where water depth was maintained at 30–50 cm and hydraulic loading rate was at 6.3–18.8 cm/day. The wetland system was found to be adequate for treating polluted stream water with stable removal e ciency even during the winter. The integrated modeling system (modified-BASINS) was applied to the Seokmoon estuarine reservoir watershed and calibrated with monitoring data from constructed wetland, stream, and reservoir. The calibrated integrated modeling system estimated that constructing wetlands on 0.5% (about 114 ha) of the watershed area at the mouth of reservoir could reduce 11.61% and 13.49% of total external nitrogen and phosphorus loads, respectively. It also might improve the nitrogen and phosphorus concentration of the reservoir by 9.69% and 16.48%, respectively. The study suggested that about 0.1%–1.0% of the watershed area should be allocated for constructed wetland to meet specified water-quality standards for the estuarine reservoir at the polder area where land use planning is relatively less complicated.     

Evaluation of mercury speciation and removal through air pollution control devices of a 190 MW boiler

Air pollution control devices (APCDs) are installed at coal-fired power plants for air pollutant regulation. Selective catalytic reduction (SCR) and wet flue gas desulfurization (FGD) systems have the co-benefits of air pollutant and mercury removal. Configuration and operational conditions of APCDs and mercury speciation a ect mercury removal e ciently at coal-fired utilities. The Ontario Hydro Method (OHM) recommended by the U.S. Environmental Protection Agency (EPA) was used to determine mercury speciation simultaneously at five sampling locations through SCR-ESP-FGD at a 190 MW unit. Chlorine in coal had been suggested as a factor a ecting the mercury speciation in flue gas; and low-chlorine coal was purported to produce less oxidized mercury (Hg2+) and more elemental mercury (Hg0) at the SCR inlet compared to higher chlorine coal. SCR could oxidize elemental mercury into oxidized mercury when SCR was in service, and oxidation e ciency reached 71.0%. Therefore, oxidized mercury removal e ciency was enhanced through a wet FGD system. In the non-ozone season, about 89.5%–96.8% of oxidized mercury was controlled, but only 54.9%–68.8% of the total mercury was captured through wet FGD. Oxidized mercury removal e ciency was 95.9%–98.0%, and there was a big di erence in the total mercury removal e ciencies from 78.0% to 90.2% in the ozone season. Mercury mass balance was evaluated to validate reliability of OHM testing data, and the ratio of mercury input in the coal to mercury output at the stack was from 0.84 to 1.08.